Welcome to the official website of Luoyang Yixin Environmental Protection Technology Co., Ltd.!
Dedicated to air pollution control
Design, Development, Production, Sales, Installation, and Maintenance Services
14
2023
-
01
Bag filter supplier: How to maintain a bag filter?
Author：
Bag filter supplier Introduction: Bag filters are widely used and will be used in many industries. As is known to all, many industries have created a large number of dust-like air pollution sources during the entire consumption process. Such air pollution sources are very harmful to the environment and therefore need to be stopped immediately. To successfully address this problem, it can poison and consume dust that cannot be stopped throughout the process. Bag filters can effectively filter out dust and other air polluting compounds from the air. Bag filters operate continuously for 24 hours and should be repaired immediately.
Bag filter How to maintain?
1. Immediately remove and replace the filter material used to secure steam, as well as the water and oil filter, filter system, air compressor, air compressor, air tank, airbag and filter element used to secure air. This takes about 4-6 months, and all of these need to be repaired, maintained, disassembled and replaced.
2. The operation of a bag filter is energy-consuming, and it is also necessary to assign personnel to conduct regular inspections and write operating instructions. The selected personnel are familiar with the basic principles of bag filters, can stop maintenance, and can find missing parts and abnormalities in the middle. However, it should be noted that if dust is found at the exhaust port after each dust removal, it may be necessary to adjust the dust removal cycle due to excessive dust removal.
Precautions when operating a bag filter:
1. The rotation direction, transmission ratio, rolling bearing vibration and temperature of the centrifugal fan.
2. Whether the pressure, temperature and various functional tests of the processed air volume are consistent with the scheme design.
3. The installation of the dust collector bag, whether there is bag falling or damage after use, etc. After putting into use, the wastewater treatment of the flue pipe can be evaluated and identified.
4. Pay attention to whether there is condensed water in the dust chamber, whether the ash discharge system is smooth, and whether the production and processing prevent damage caused by blockage, corrosion and serious dust accumulation.
5. The adjustment of the dust removal cycle and time is a factor that affects the dust removal characteristics and operating status of various tasks. If the dust removal time is too long, the adhered dust layer will be removed, which is the reason for the leakage and damage of the dust collector bag. If the dust removal time is too short, the dust on the dust collector bag will not be cleaned, and it will be repaired and gradually improved during the filtration process, which will damage its expected effect.
The bag filter supplier said, The time interval between two dust removal operations is called the dust removal cycle. Generally, it is hoped that the dust removal cycle is as long as possible, so that the bag filter can operate under the friction standard of economic development. Therefore, during the trial operation, attention should be paid to the dust characteristics and dust concentration values, and the dust removal cycle and time should be managed and determined according to different dust removal methods, and the basic dust removal parameters should be adjusted.
At the beginning of operation, some unpredictable situations often occur, such as abnormal temperature, pressure, humidity, etc., which will damage the new equipment. A sharp change in the temperature of acetylene gas will cause the centrifugal fan shaft to deform, leading to an unbalanced state and vibration during operation.
The company mainly produces various dust removal, desulfurization, denitrification, VOCs waste gas purification, wastewater treatment, noise reduction, complete sets of industrial electrical control systems and equipment, and researches and develops waste gas, wastewater, waste residue, and noise treatment equipment.
Contact Us
Telephone:+86-379-67323008
Phone:+86-5824998401
+86-9838965599
Email:yx23008@163.com
Address: Xin'an County Economic and Technological Development Zone, Luoyang City, Henan Province
